Differential Thrust Washer Gage Installation
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Differential Thrust Washer Gage Installation
| Callout | Component Name |
|---|---|
| 1 | Front Differential Carrier Assembly Tip: Install the differential assembly and the pinion gear assembly together to avoid interference with the gears during installation. |
| 2 | Front Differential Drive Pinion (w/Transfer Gear) Gear Assembly Tip: Install the differential assembly and the pinion gear assembly together to avoid interference with the gears during installation. |
| 3 | Front Differential Drive Pinion Gear Bearing Cup Tip: After placing the bearing cup on the gear, place DT 47800-2 which is part of DT-47800: selection gage kit, onto the bearing cup. Special Tools: DT-47800: Thrust Washer Selection Gage Kit For equivalent regional tools, refer to Special Tools . |
| 4 | Front Differential Carrier Bearing Cup Tip: After placing the bearing cup on the gear, place DT 47800-1 which is part of DT-47800: selection gage kit, onto the bearing cup. Special Tools: DT-47800: Thrust Washer Selection Gage Kit For equivalent regional tools, refer to Special Tools . |
| 5 | Torque Converter Housing Outer Seal |
| 6 | Torque Converter and Support and A/Trans Fluid Pump Housing Assembly Tip: Install 2 DT 47800-6 which is part of DT-47800: selection gage kit, into a case threaded hole at approximately 180 degrees apart. Tip: Some alignment of DT 47800-1 and 2 which is part of DT-47800: selection gage kit, may be required while lowering the TC housing onto the case. Install DT 47800-3 which is part of DT-47800: selection gage kit, spacer over DT 47800-6. Special Tools: DT-47800: Thrust Washer Selection Gage Kit For equivalent regional tools, refer to Special Tools . |