LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 900) >> Repair Instructions - On Vehicle >> Transfer Case Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transfer Case Mounting Bracket
    GM928962Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the transfer case mounting bracket to the vehicle and hand start all bolts.

    Tighten the bolts to 50 N.m (37 lb ft).

    2. Fig 2: View Of Crankshaft Position Sensor & Knock Sensor Electrical Connectors
    GM1371165Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connectors to the crankshaft position sensor (2) and the knock sensor (1).
  3. Install the right hand axle. Refer to Front Wheel Drive Shaft Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals