LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 900) >> Repair Instructions - On Vehicle >> Axle Shaft Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .
    3. Fig 1: View Of Stub Shaft Retainer Ring
    GM928957Courtesy of GENERAL MOTORS CORP.
  3. Remove the retainer ring from the stub shaft for tool installation. Discard the used retainer ring.
  4. Remove the stub shaft using the J 6125-1B  and J 38868  . See Special Tools .
    5. Fig 2: View Of Output Shaft Seal
    GM850513Courtesy of GENERAL MOTORS CORP.
  5. Carefully, remove the output shaft seal and discard.
scientia non olet · About LEMON Manuals