LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (HVAC System - Manual) >> Repair Instructions >> Mode Valve Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Mode Actuator
    GM1646796Courtesy of GENERAL MOTORS CORP.
  1. Install the mode actuator to the evaporator case assembly.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the mode actuator screws to the evaporator case assembly.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  3. Connect the electrical connector to the mode actuator.
  4. Install the communication interface module, if equipped. Refer to Communication Interface Module Replacement .
  5. Install the left side insulator/closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
    6. NOTE: Any time a mode actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure proper air distribution.
  6. Calibrate the actuators. Refer to Actuator Recalibration .
  7. Cycle the ignition and verify proper operation.
scientia non olet · About LEMON Manuals