On The Hoist
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the scan tool to the vehicle diagnostic connector and turn the ignition ON.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH 48027) or Fuel Pressure Relief (With CH 48027) .
- Raise the vehicle on a hoist to a comfortable working height, keeping the scan tool outside of the vehicle and accessible from under the car.
- Disconnect the chassis fuel feed line quick connect fitting at the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service .
- Install the 3/8 x 1/4 in quick connect fitting adapter (1) from the J 34730-262 onto the fuel feed line. See Special Tools .
- Connect a suitable drain hose to the other end of the adapter, and connect the drain hose to a certified fuel handling cart.
- Energize the fuel pump using the scan tool. Refer to Fuel Pump Electrical Circuit Diagnosis .
- Pump out the fuel until no more than 1/4 tank remains.
WARNING:
Fuel supply lines will remain pressurized for long periods of time after the engine is shutdown. This pressure must be relieved before servicing the fuel system.
WARNING:
Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
WARNING:
Whenever fuel line fittings are loosened or removed, wrap a shop cloth around the fitting and have an approved container available to collect any fuel.