LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left CMP Sensor - Intake
    GM1285241Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Engine Wiring Harness Electrical Connector, HO2S Electrical Connector & Retainer
    GM1836024Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor.
  4. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals