LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector, HO2S Electrical Connector & Retainer
    GM1836024Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Disconnect the engine wiring harness electrical connector (6) from the bank 2 exhaust camshaft position (CMP) sensor.
    3. Fig 2: View Of Left CMP Sensor - Exhaust
    GM1285243Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals