LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right CMP Actuator Valve - Exhaust
    GM1285202Courtesy of GENERAL MOTORS CORP.
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
  2. Install the CMP actuator solenoid valve.
  3. CAUTION: Refer to Fastener Caution .
  4. Install the CMP actuator solenoid valve bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  5. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1836625Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector (5) to the bank 1 exhaust CMP actuator solenoid valve.
  7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .