LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Seat Heating System & Seat Cooling System) >> Repair Instructions >> Driver or Passenger Seat Cushion Heater Replacement (With Passenger Presence System) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Cushion Heater Element
    GM987804Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the back of the heater element.
  2. Position the heater element over the seat foam pad and align the tabs and holes of the heater element to the seat foam. Press firmly to engage the adhesive.
  3. Route the heating element wiring harness under the seat pad and connect the harness to the heater module. Secure the wire with tie straps.
  4. Install the seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
  5. Install the front seat to the vehicle. Refer to Front Seat Replacement - Bucket .
    6. IMPORTANT: Perform the passenger presence system preload test procedure when performing any repairs to the passenger seat.
  6. Preload test the inflatable restraint passenger presence system for the front passenger seat. Refer to Control Module References .
scientia non olet · About LEMON Manuals