Circuit/System Testing: Notes
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
B2345 00
- Ignition OFF, disconnect the X1 harness connector at the HSM.
- Test for infinite resistance between the control circuit terminal 3 and ground.
- If less than the specified range, test the control circuit for a short to ground.
- Test for infinite resistance between the control circuit terminal 6 and ground.
- If less than the specified range, test the control circuit for a short to ground.
- Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.
- If the test lamp illuminates, test the control circuit for a short to voltage.
- Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 6 and ground.
- If the test lamp illuminates, test the control circuit for a short to voltage.
- If all circuits test normal, replace the HSM.
B2345 13
- Ignition OFF, disconnect the X2, X4 harness connector at the HSM.
- Test for greater than 1.9K ohms between the signal and low reference circuits listed below:
- Driver seat cushion terminal 9 X4 and terminal 6 X2
- Passenger seat cushion terminal 20 X4 and terminal 8 X2
- If less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the appropriate seat temperature sensor.
- If all circuits test normal, replace the HSM.