Removal Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Gasoline/Gasoline Vapors Warning .

Fig 1: View Of Quick-Connect Fitting Retainer (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Relieve the fuel system pressure before servicing any fuel system connection. Refer to the Fuel Pressure Relief (Without CH 48027) or Fuel Pressure Relief (With CH 48027) .
Remove the retainer from the quick-connect fitting.

Fig 2: Blowing Dirt Out Of Fitting (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Safety Glasses Warning .

CAUTION: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Caution .

Blow dirt out of the fitting using compressed air.

Fig 3: View Of Quick Connect Locking Tabs (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Choose the correct tool from the J 37088-A for the size of the fitting. See Special Tools . Insert the tool into the female connector, then push inward in order to release the locking tabs.

Fig 4: View Of Quick Connect Locking Tabs (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Relieving Fuel Pressure Warning .

Pull the connection apart.
Use a clean shop towel in order to wipe off the male pipe end.
Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.