LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Controls And Fuel - 3.4L - Introduction) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Purge Hose/Pipe
    GM1371130Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP hose/pipe (2) to the vehicle.
  2. Install the EVAP hose/pipe (2) to the retainer (3).
    3. Fig 2: View Of EVAP Purge Pipe
    GM879155Courtesy of GENERAL MOTORS CORP.
  3. Remove the caps or plugs from both the engine and chassis EVAP purge hose/pipes.
  4. Connect the engine EVAP purge hose/pipe to the chassis EVAP purge hose/pipe. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View Of EVAP Purge Hose/Pipe
    GM1371130Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP purge hose/pipe (2) to the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    6. CAUTION: Refer to Fastener Caution .
  6. Install the nuts (1) securing the evaporative emission EVAP hose/pipe (2) to the strut tower.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals