Measuring the Z Height
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- In order to obtain the proper measurement, Z will equal inner minus the outer.
- The left and right Z height difference should be no more than 12 mm (0.47 in).
Use the following procedure to measure the Z height:
- Lift the front bumper of the vehicle up about 38 mm (1.5 in).
- Gently remove your hands and let the vehicle settle.
- Repeat this operation 2 more times for a total of 3 times.
- Repeat this jouncing operation 2 more times for a total of 3 times.
- Measure from the center of the lower ball joint (A) to the alignment rack.
- Measure from the center of the cradle (B) to the alignment rack.
- The difference between these 2 measurements is the Z height.
- Push the front bumper of the vehicle down about 38 mm (1.5 in).
- Gently remove your hands and let the vehicle settle.
- Repeat this operation 2 more times for a total of 3 times.
- Re-measure the Z height as in step 4.
- The true Z height is the average of the measurements taken in steps 4 and 8. Refer to Trim Height Specifications .
If any of these measurements are out of specifications, inspect for the following conditions:
- Worn or damage suspension components
- Collision damage