LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Cooling System) >> Repair Instructions >> Heater Inlet Pipe Replacement (LNJ) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new seal (3) to the heater inlet pipe (1).
  2. Apply engine coolant to the heater inlet pipe seal (3).
    3. Fig 1: View Of Heater Inlet Pipe, Nut & Seal
    GM1087621Courtesy of GENERAL MOTORS CORP.
  3. Install the heater outlet pipe (1).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the heater inlet pipe nut (2) and tighten to 25 N.m (18 lb ft).
    5. Fig 2: Disconnecting/Connecting Heater Core Inlet Hose At Heater Inlet Pipe
    GM1327499Courtesy of GENERAL MOTORS CORP.
  5. Connect the heater core inlet hose to the heater inlet pipe.
  6. Position the heater core inlet hose clamp over the heater inlet pipe connection.
  7. Fill the cooling system. Refer to Cooling System Draining and Filling (LY7 GE 47716 Fill)  or Cooling System Draining and Filling (LNJ GE 47716 Fill)  or Cooling System Draining and Filling (LNJ Static Fill)  or Cooling System Draining and Filling (LY7 Static Fill) .
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals