Circuit/System Testing
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X3 harness connector at the BCM.
- Ignition ON, verify the security indicator is not illuminated.
- If the security indicator is illuminated, test the control circuit terminal 7 for a short to ground. If the circuit tests normal, replace the IPC.
- Install a 10A fused jumper wire between the control circuit terminal 7 and ground. Verify the security indicator is illuminated.
- If the security indicator is not illuminated, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the IPC.
- If all circuits test normal, replace the BCM.