Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Position the power steering gear into the vehicle through the left wheel house area.
- Install the power steering gear bolts (1) and tighten to 110 N.m (81 lb ft).
- If equipped, install the power steering gear hoses bracket bolt (1) and tighten to 9 N.m (80 lb in).
- If equipped, clip the power steering gear hose to the bracket.
- Connect the power steering gear inlet hose (2) and the power steering fluid cooler hose (1) to the power steering gear.
Tighten to 25 N.m (18 lb ft).
- Install the transaxle mount and transaxle mount bolts (1) and tighten to 50 N.m (37 lb ft).
- Install the transaxle mount bolt (1) and tighten to 110 N.m (81 lb ft).
- Clean any excess fluid from the vehicle and remove the drain pans.
- Install the intermediate steering shaft lower bolt. Refer to Intermediate Steering Shaft Replacement .
- Connect the rack and pinion outer tie rods to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement .
- Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
- Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
CAUTION:
Refer to Fastener Caution
.