LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Engine Exhaust System) >> Repair Instructions >> Exhaust Manifold Heat Shield Replacement - Right Side (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Exhaust Manifold Heat Shield
    GM1562768Courtesy of GENERAL MOTORS CORP.
  1. Install the exhaust manifold heat shield, sliding the shield down over the HO2S pigtail.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the exhaust manifold heat shield bolts and tighten to 10 N.m (89 lb in).
    3. Fig 2: Identifying Engine Wiring Harness Electrical Connector & Heated Oxygen Sensor (HO2S) Electrical Connector
    GM1836230Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (3) to the HO2S electrical connector (2).
  4. Install the HO2S electrical connector retainer to the camshaft cover.
  5. Install the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals