Underhood Electrical Center or Junction Block Bracket Replacement

Fig 1: View Of Underhood Electrical Center or Junction Block Bracket

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure:  Remove the underhood electrical center or junction block. Refer to Underhood Electrical Center or Junction Block Replacement .
1	Underhood Electrical Center or Junction Block Bracket Bolt NOTE: Refer to Fastener Notice . Procedure:  Remove the electrical connector inside the block before removing the bracket. Tighten:  20 N.m (15 lb ft)
2	Underhood Electrical Center or Junction Block Bracket