Rear Crankshaft Main Bearing Seal: Service and Repair

Crankshaft Rear Oil Seal Replacement

Tools Required

J 42067 Rear Main Seal Installer


Removal Procedure





1. Remove the flywheel. Refer to Engine Flywheel Replacement (Service and Repair) .

Important: Do not damage the outside diameter of the crankshaft or chamber with any tool.


2. Pry out the crankshaft rear oil seal using a flat-bladed tool.



Installation Procedure





1. Using the J 42067 , install a NEW crankshaft real oil seal.
2. Install the flywheel. Refer to Engine Flywheel Replacement (Service and Repair) .