Rear License Lamp Replacement (Solstice)

Fig 1: View Of Rear License Lamp & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Rear License Plate Lamp Assembly Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten:  2 N.m (18 lb in)
2	Rear License Plate Lamp Assembly Tip:  Push one side of the lamp assembly inside the rear bumper cover hole and pull downward to disconnect the electrical connector.
3	Rear License Plate Electrical Connector Tip:  Twist the socket counterclockwise in order to remove from the lamp housing.
4	Rear License Plate Bulb Tip:  Replace the bulb as needed.