Control Lever and/or Boot Replacement (Solstice)

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Shift Control Knob, Boot & Screw

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Lift up the lower edge of the instrument panel cluster trim plate only enough to reach fingers underneath in order to release the shift boot bezel retaining tabs.
1	Shift Control Lever Boot Bezel Tip: Release the shift control boot bezel retaining tabs from the instrument cluster trim panel.
2	Shift Control Lever Screw NOTE: Refer to Fastener Notice . Procedure Lift the shift boot up for access. It is not necessary to fully remove the screw in order to release the control lever. Ensure the screw is lined up with the flat on the transmission shift lever before tightening. Tighten: 10 N.m (89 lb in)
3	Shift Control Lever Knob Tip: The shift control knob and boot must be replaced as an assembly.