Control Lever and/or Boot Replacement (SKY)

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Control Lever, Boot & Retaining Screw

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Shift Boot Bezel Tip: Grasp the edge of the shift boot bezel by reaching under the bezel from the soft boot area. Lift the shift boot bezel up to release the bezel from the instrument panel cluster trim plate.
2	Shift Control Lever Retaining Screw NOTE: Refer to Fastener Notice . Procedure Lift the shift boot up for access. It is not necessary to fully remove the screw in order to release the control lever. Ensure the screw is lined up with the flat on the transmission shift lever before tightening. Tighten: 10 N.m (89 lb in)
3	Shift Control Lever Knob and Boot Tip: The shift control lever knob and boot must be replaced as an assembly.

Callout

Component Name

Shift Boot Bezel
Tip: Grasp the edge of the shift boot bezel by reaching under the bezel from the soft boot area. Lift the shift boot bezel up to release the bezel from the instrument panel cluster trim plate.

Shift Control Lever Retaining Screw

NOTE: Refer to Fastener Notice .

Procedure

Lift the shift boot up for access.
It is not necessary to fully remove the screw in order to release the control lever.
Ensure the screw is lined up with the flat on the transmission shift lever before tightening.

Tighten: 10 N.m (89 lb in)

Shift Control Lever Knob and Boot
Tip: The shift control lever knob and boot must be replaced as an assembly.