Windshield Washer Solvent Container Replacement (SKY)

Fig 1: View Of Washer Hose Pump, Washer Container, Pump & Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Base) or Front Wheelhouse Liner Replacement (Turbo) . Drain the washer solvent into a suitable clean container.
1	Windshield Washer Pump Hose Assembly Procedure Disconnect the hose at the hinge pillar and air inlet panel. Disengage the integral washer hose clip from the electronic control module (ECM) bracket.
2	Windshield Washer Solvent Container Screw (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
3	Windshield Washer Container Assembly Tip: Lower the windshield washer container from behind the left front fender area.
4	Windshield Washer Container Pump Kit Tip: Disconnect the washer hose at the pump and use 2 flat-bladed tools and pry the washer pump from the container.