LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix V6-3.8L >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> Assemble, Disassemble, and Installation >> Input Clutch Housing Fluid Seal Ring Assemble

Input Clutch Housing Fluid Seal Ring Assemble



Input Clutch Housing Fluid Seal Ring Assemble

Tools Required

J 34741-A Input Seal Installer contains:

* J 34741-1 Adjustable Seal Protector
* J 34741-2 Seal Pusher
* J 34741-3 Seal Sizer






1. Install J 34741-1 into the input clutch housing (632). Adjust J 34741-1 so that the bottom of the seal installer aligns with the lowest seal ring groove.
2. Use transmission fluid in order to lubricate the oil seal ring for the input clutch housing. Position the ring on the J 34741-1 .




3. Position J 34741-2 onto the J 34741-1 . Push the seal (628) into the seal ring groove.




4. Repeat this procedure for the second and the third seal rings (628).




5. Remove the input seal installer.
6. Use a twisting motion in order to assemble J 34741-3 over the seals.
7. Leave J 34741-3 in place until the input clutch housing assembly (632) is assembled into the transmission.


scientia non olet · About LEMON Manuals