LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Fluid Filler Tube Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Fluid Filler Tube & Bracket Bolt
    GM161126Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do NOT place the fluid filler tube seal on the fluid filler tube when installing the tube or damage to the seal will result.
  1. Install the fluid filler tube seal in the transaxle.
  2. Position the fluid filler tube.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the fluid filler tube bracket bolt.

    Tighten:  Tighten the bolt to 13 N.m (115 lb in).

  4. Install the catalytic converter. Refer to Catalytic Converter Replacement (L26) or Catalytic Converter Replacement (LS4) .
  5. Lower the vehicle.
    6. NOTE: Do not overfill the transmission. Overfilling will result in foaming, loss of fluid, and possible damage to the transmission.
  6. Check and fill the transaxle as necessary.
  7. Install the transaxle oil level indicator.
  8. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals