Installation Procedure
- Install the oil pump (200) to the valve body (300).
- Install the oil pump bolts (230, 231).
Tighten:
- Tighten the nine (231) M6 X 1.0 X 85 bolts to 12 N.m (106 lb in).
- Tighten the two (230) M6 X 1.0 X 95 bolts to 16 N.m (12 lb ft).
- Install the case side cover. Refer to Control Valve Body Cover Replacement .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned. Reset the TAP values. Refer to Transmission Adaptive Functions .
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned. Reset the TAP values. Refer to Transmission Adaptive Functions .