LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Oil Seal Replacement - Left Side >> Installation Procedure

Installation Procedure

  1. Lubricate the seal lip with transaxle fluid.
    2. IMPORTANT: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
  2. Install J 37292-B  in the seal (409). See Special Tools .
    3. Fig 1: Installing Oil Seal - Left
    GM190634Courtesy of GENERAL MOTORS CORP.
  3. Use J 34115  to install the new seal. See Special Tools .
  4. Remove the J 37292-B  . See Special Tools .
  5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  6. Install the left lower ball joint to the left steering knuckle. Refer to Steering Knuckle Replacement .
  7. Install the left tie rod end to the left steering knuckle. Refer to Steering Knuckle Replacement .
  8. Install the left stabilizer shaft link to the left lower stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
  9. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
    11. NOTE: Do not overfill the transmission. Overfilling will result in foaming, loss of fluid, and possible damage to the transmission.
  11. Adjust the fluid level.
  12. Inspect for proper completion of the repairs.
  13. Inspect for proper fluid level.
  14. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals