LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Case Extension Replacement >> Installation Procedure

Installation Procedure

  1. If removed, install the drive axle seal. Refer to Front Wheel Drive Shaft Oil Seal Replacement - Right Side .
    2. Fig 1: View Of Case Extension Assembly & Bolts
    GM10517Courtesy of GENERAL MOTORS CORP.
  2. Install the O-ring (8) to the case extension housing (6).
  3. Install the case extension housing (6) with the axle seal and the O-ring (8).
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the case extension housing bolts (5).

    Tighten:  Tighten the bolts to 36 N.m (27 lb ft).

  5. Install the vehicle speed sensor. Refer to Vehicle Speed Sensor Replacement .
  6. Install the transaxle brace. Refer to Automatic Transmission Brace Replacement .
  7. Install the right drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  8. Lower the vehicle.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LS4) .
    10. NOTE: Do not overfill the transmission. Overfilling will result in foaming, loss of fluid, and possible damage to the transmission.
  10. Check and fill the transaxle as necessary.
  11. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals