Installation Procedure

Fig 1: Tap Shift Switches

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the screws to the automatic transmission shift auxiliary position switches (1).
Tighten: Tighten the automatic transmission shift auxiliary position switch retaining screws to 3.5 N.m (31 lb in).

Fig 2: Steering Wheel Cover

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the radio control switches (2).
Install the steering wheel radio controls (2).
Install the retaining screws (1) to the steering wheel radio controls (2).
Tighten: Tighten the radio control retaining screws to 3.5 N.m (31 lb in).
Enable the SIR System. Refer to SIR Disabling and Enabling .