Wiring Harness Assemble

Fig 1: View Of Wiring Harness Assembly

Courtesy of GENERAL MOTORS CORP.

Inspect the wiring harness assembly (225) for:
- Cut or pinched wires
- Cut wire insulation
- Bent or broken electrical connectors
- Damaged terminal pins

Fig 2: Aligning Wire Harness Onto Control Valve Body

Courtesy of GENERAL MOTORS CORP.

Position the wire harness assembly (225) onto the control valve body (300) and the pump cover (201).
Mate each connector into its respective electrical component and engage the locking tabs.
Secure the wiring harness conduit into the retaining clip (226) on the pump cover (201).
Assemble the fluid temperature sensor (391) into the temperature sensor clip (390).