Tools Required

J 28585  Snap Ring Remover. See Special Tools .

Fig 1: View Of Differential Carrier Internal Gear Snap Ring & Thrust Washer
Courtesy of GENERAL MOTORS CORP.
1. Remove the bearing (691) from the differential carrier internal gear.
2. Use J 28585  or a large screwdriver in order to remove the differential carrier internal gear snap ring (692). See Special Tools .
Fig 2: Removing Differential Carrier Internal Gear Assembly
Courtesy of GENERAL MOTORS CORP.
3. Lift the differential carrier internal gear assembly (693) out of the case by depressing the park pawl assembly in order to clear the case.