Case Cover Bearing Assemble

Tools Required

• J 8092  Driver Handle. See Special Tools .
• J 41991  Driveshaft Bearing Remover/Installer. See Special Tools .

Fig 1: Pressing Drive Shaft Bearing In With J 8092 & J 41991
Courtesy of GENERAL MOTORS CORP.
1. Assemble J 8092  and J 41991  for bearing installation. See Special Tools .
2. Place the case cover (400) on a clean, flat surface with the case mating surface up.
IMPORTANT: When installing the new bearing the part number should be visible (facing upward).
3. Using the assembled tool, press the drive shaft bearing (431) into the case cover (400).