Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0201-P0206, P0300, P0350, P0411, P0412, P0418, P0420, P0606, P0641, P0651, P1350, P2430, P2431, P2432, P2433 are not set.
The system voltage is 9-18 volts.
The BARO parameter is more than 60 kPa.
The MAF sensor parameter is between 3-24 g/s.
The AIR system is commanded ON.
The start-up engine coolant temperature (ECT) is between 5-50°C (41-122°F).
The start-up intake air temperature (IAT) is between 5-60°C (41-140°F).
The conditions are stable for more than 5 seconds.
DTC P2440 runs once per trip start up when the above conditions are met and AIR pump operation is requested.