Conditions for Running the DTC

P1125

• DTCs P0606, P2108, and U0107 are not set.
• The ignition is ON.
• The communication between the TAC module and the PCM must be valid.

P2120 and P2125

• The system voltage is more than 5.23 volts.
• The ignition is in the Unlock/Accessory, Run, or Crank position.
• DTC P2107 is not set.
• The DTCs run continuously when the above conditions are met.

P2138

• The system voltage is more than 5.23 volts.
• The ignition is in the Unlock/Accessory or Run position.
• DTC P2107 or P2108 is not set.
• The DTC runs continuously when the above conditions are met.