Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0016, P0101, P0102, P0103, P0107, P0108, P0116, P0117, P0118, P0120, P0128, P0220, P0335, P0336, P0608, P1516, P2101, P2119, P2120, P2125, P2135, or P2138 are not set.
DTC P0315 is not set and the engine speed is between 525-6,000 RPM.
OR
DTC P0315 is set and the engine speed is less than 1,000 RPM.
The ignition voltage is between 9-18 volts.
The engine coolant temperature (ECT) parameter is between -7 and +123°C (+19 and +253°F).
If the ECT is less than -7°C (+19°F) at engine start-up, this diagnostic is disabled until the ECT is more than +21°C (+69°F).
The fuel level is more than 10 percent.
The antilock brake system (ABS) and the traction control system (TCS) are not active or detecting rough road.
The PCM is not in fuel shut-off or decel fuel cut-off mode.
The power management is not active.
Excessive drive wheel slip is not detected.
DTC P0300-P0306 run continuously when the above conditions are met.