Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the appropriate fuel injector.
- Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal A and ground.
- If the test lamp does not illuminate, test the ignition circuit for a short to ground, or an open/high resistance. If the circuit tests normal and the ignition circuit fuse is open, test or replace the fuel injector.
- Ignition OFF, connect a J 34730-405 between the control circuit terminal B and the ignition circuit terminal A, of the appropriate fuel injector.
- Engine running, the test lamp should flash.
- If the test lamp is always ON, test the appropriate control circuit for a short to ground. If the circuit tests normal, replace the ECM.
- If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the fuel injector.