Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0125-L32 only, P0128, P0401, P0403, P0404, P0405, P0406, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P1106, P1107, P1111, P1112, P1114, P1115, or P1404 are not set.
The engine is running.
The ignition 1 signal is between 9-18 volts.
If the ignition 1 signal is less than 11.5 volts, then the MAF must be less than 40 g/s.
The throttle position indicated angle is less than or equal to 100 percent.
The change in the throttle position indicated angle is less than or equal to 15 percent.
The traction control is inactive, if equipped.
The exhaust gas recirculation (EGR) flow diagnostic is inactive.
The EGR is less than or equal to 100 percent.
The EGR DC is less than or equal to 100 percent.
The EVAP canister purge valve duty cycle is less than or equal to 100 percent.
The MAP sensor is less than 80 kPa.
The change in the MAP sensor is less than 5 kPa.
The above conditions are met for more than 2 seconds.