LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Oil Pump Suction Pipe and Screen Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Remove the oil level sensor, located in the oil pan, before the oil pan is removed. The sensor may be damaged if the oil pan is removed first.
  1. Remove the oil pan. Refer to Oil Pan Replacement .
    2. Fig 1: Oil Pump Screen & Bolts
    GM153599Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil pump screen bolts.
  3. Remove the oil pump pipe and screen.
  4. Remove the oil pump pipe and screen gasket.
  5. Clean the screen and housing with solvent, and blow dry.
  6. Inspect the oil pump pipe and screen, replace if necessary.
  7. Clean the gasket mating surface on the pipe flange and cylinder block.
scientia non olet · About LEMON Manuals