LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Mount Strut Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Mount Strut
    GM97613Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolt and the nut to the right engine mount strut at the right engine mount strut bracket on the upper radiator support.

    Tighten:  Tighten the engine mount strut bolt to 48 N.m (35 lb ft).

    3. Fig 2: Right Engine Mount Strut Bolt & Nut (L26)
    GM1210280Courtesy of GENERAL MOTORS CORP.
  3. With a L26 Engine, install the bolt and the nut to the right engine mount strut at the right engine mount strut bracket on the engine.

    Tighten:  Tighten the engine mount strut nut to 48 N.m (35 lb ft).

    4. Fig 3: Right Engine Mount Strut Bolt & Nut (L32)
    GM1210282Courtesy of GENERAL MOTORS CORP.
  4. With a L32 Engine, install the bolt and the nut to the right engine mount strut at the right engine mount strut bracket on the engine.

    Tighten:  Tighten the engine mount strut nut to 48 N.m (35 lb ft).

scientia non olet · About LEMON Manuals