Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Holding Flywheel

Courtesy of GENERAL MOTORS CORP.

Install the engine flywheel.
Use the J 37096 to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .

Fig 2: View Of Engine Flywheel & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Install the new engine flywheel bolts.
Tighten:
1. Tighten the engine flywheel bolts to 15 N.m (11 lb ft).
2. Use the J 45059 to rotate the engine flywheel bolts an additional 50 degrees.
Measure the engine flywheel runout:
1. Install a dial indicator on the engine block and check the engine flywheel runout at three attaching bosses. Refer to Engine Mechanical Specifications .
2. If the condition cannot be corrected, replace the engine flywheel.
Install the transaxle. Refer to Transmission Replacement .