LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Idler Pulley Bracket & Bolts
    GM327162Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley bracket.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the idler pulley bracket bolts.

    Tighten:  Tighten the bolts to 30 N.m (22 lb ft).

    3. Fig 2: Identifying Drive Belt Idler Pulley - Lower
    GM327164Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt idler pulley.
  4. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    5. Fig 3: View Of Supercharger Drive Belt
    GM327021Courtesy of GENERAL MOTORS CORP.
  5. Install the supercharger drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals