Valve Rocker Arm Cover Installation - Left Side

WARNING: This page is about a different variant/trim than selected.

Fig 1: Left Valve Rocker Arm Cover

Courtesy of GENERAL MOTORS CORP.

Install the valve rocker arm cover.
Apply GM P/N 12345382 (Canadian P/N 10953489) threadlocker or the equivalent to threads.

NOTE: Refer to FASTENER NOTICE .

Install the valve rocker arm cover bolts.
Tighten: Tighten the valve rocker arm cover bolts to 10 N.m (89 lb in).

Fig 2: View of Engine Mount Strut Upper Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine mount strut upper bracket bolts (1) if applicable.
Tighten: Tighten the engine mount strut upper bracket bolts (1) to 50 N.m (37 lb ft).
Install the engine mount strut bracket and nuts (2), if applicable.
Tighten: Tighten the engine mount strut bracket and nuts (2) to 50 N.m (37 lb ft).