Supercharger Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the spark plug wires from spark plugs and retaining clips.
- Remove the wiring harness from fuel rail.
- Remove the supercharger bypass valve harness
- Remove the fuel injector rail nuts.
- Remove the fuel injector rail.
- Remove the supercharger bypass valve nut and hose.
- Remove the supercharger bypass valve.
- Remove the engine wiring harness heat shield bolt and nut.
- Remove the engine wiring harness heat shield.
- Remove the MAP and BARO sensor retaining clips.
- Remove the MAP and BARO sensors.
- Remove the MAP/BARO sensor bracket bolts and bracket.
- Remove the throttle body bolts and nuts.
- Remove the throttle body and seal.
- Remove the bolts and the stud from the supercharger.
- Remove the supercharger.
- Remove the supercharger gasket.
IMPORTANT:
Note the location of the bolts and the bolt sizes to aid in installation.