Exhaust Manifold Installation - Right Side (With A.I.R.)
WARNING: This page is about a different variant/trim than selected.
- Install the exhaust manifold studs.
Tighten: Tighten the exhaust manifold studs to 10 N.m (89 lb in).
- Install the exhaust manifold gasket.
- Install the exhaust manifold.
- Install the exhaust manifold bolts and nuts.
Tighten: Tighten the exhaust manifold bolts and nuts to 30 N.m (22 lb ft).
- Install the right side spark plugs.
Tighten: Tighten the spark plugs to 15 N.m (11 lb ft).
- Install the fuel injector sight shield cover bracket.
- Install the fuel injector sight shield cover bracket nuts.
Tighten: Tighten the fuel injector sight shield bracket nuts to 30 N.m (22 lb ft).
- Install the right engine lift hook.
- Install the right engine lift hook nut and bolt.
Tighten: Tighten the right engine lift hook nut and bolt to 30 N.m (22 lb ft).
- If necessary, install the secondary air pipe (644), gasket (647), and bolts (646) and assemble the injection pump (636) onto bracket (648).
Tighten: Tighten the secondary air injection pump pipe bolts to 10 N.m (89 lb in).
- Install gasket (645), secondary air injection pump assembly and nuts (641) onto the engine.
Tighten: Tighten the secondary air injection pump assembly nuts to 10 N.m (89 lb in).
- Install the secondary air injection pump assembly mounting bolts (637, 649).
Tighten: Tighten the secondary air injection pump assembly mounting bolts to 10 N.m (89 lb in).
- Loosen the hose clamp and install the secondary air injection pipe (640) onto the valve and reinstall the hose clamp.
NOTE:
Refer to FASTENER NOTICE
.
NOTE:
When replacing the HO2S perform a code clear with a scan tool, regardless of whether or not a DTC is set. Performing a code clear will reset the HO2S resistance learned value. Failure to perform a code clear may result in an HO2S failure.