Engine Flywheel Installation

Tools Required

• J 37096  Flywheel Holder. See Special Tools .
• J 45059  Angle Meter

Fig 1: Engine Flywheel & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Install the flywheel.
Fig 2: Holding Flywheel
Courtesy of GENERAL MOTORS CORP.
2. Use the J 37096  to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .
NOTE: Refer to FASTENER NOTICE .
3. Install the new flywheel bolts.

   Tighten:  Tighten the bolts to 15 N.m (11 lb ft). Use the J 45059  to tighten the bolts an additional 50 degrees.