LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the MAF/IAT sensor to the air cleaner intake duct.
  2. Install the air cleaner intake duct to the air cleaner housing cover and the throttle body assembly.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the air cleaner intake duct clamp screws.

    Tighten:  Tighten the duct clamps to 3 N.m (27 lb in).

  4. Connect the MAF/IAT sensor electrical connector.
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals