LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Female Connector & Fuel Rail Pipe
    GM910914Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The evaporative emission (EVAP) purge valve is located on the upper intake manifold.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement for the 3.8L engine.
  2. Disconnect the EVAP canister purge valve purge pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP canister purge valve electrical connector.
    4. Fig 2: Identifying Throttle Body Assembly (L26)
    GM911046Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP purge valve bolt (2).
  5. Remove the EVAP purge valve (3).
scientia non olet · About LEMON Manuals