LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating MAP & BARO Sensors
    GM1210599Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the BARO sensor electrical connector.
  3. Remove the BARO sensor retainer.
  4. Remove the BARO sensor.
scientia non olet · About LEMON Manuals