LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Inlet Duct Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the MAF/IAT sensor electrical connector (2).
  3. Disconnect the PCV tube.
    4. Fig 1: Identifying MAF/IAT Sensor
    GM1208107Courtesy of GENERAL MOTORS CORP.
  4. Loosen the air cleaner intake duct clamps at the throttle body and the air cleaner housing cover.
  5. Remove the air cleaner intake duct from the air cleaner cover.
  6. Remove the air cleaner intake duct from the throttle body.
  7. Remove the MAF/IAT sensor from the air cleaner intake duct.
  8. If replacing the air cleaner intake duct, remove the clamps.
scientia non olet · About LEMON Manuals