LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the left inner fender brace. Refer to Front Fender Upper Diagonal Brace Replacement .
  2. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
    3. Fig 1: View Of Air Cleaner Housing, Bolts, PCM & Harness
    GM444496Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner housing screws (2).
  4. Remove the air cleaner housing cover (1) from the air cleaner housing.
  5. Without disconnecting the powertrain control module (PCM) connectors, remove the PCM and the harness from the air cleaner housing.
    6. Fig 2: View Of Air Cleaner Housing
    GM444479Courtesy of GENERAL MOTORS CORP.
  6. Remove the air cleaner housing (1) by pulling the housing from the 2 rubber grommets (2) in the engine compartment.
  7. Inspect the air cleaner housing assembly for signs of damage and replace if necessary.
scientia non olet · About LEMON Manuals